Address Plaque Installation Guide

How to Install Your FAVPRO Address Plaque

Installing your new address plaque is simple and takes just a few minutes. Follow this step-by-step guide for a professional result that will last for years.

Tools Needed

• Electric drill 
• Level
• Pencil
• Measuring tape
• Screwdriver (if needed)

Step 1: Choose the Location

Select a location clearly visible from the street, ideally at eye level (approximately 1.5 to 1.8 meters from the ground). Ensure the location is flat and free of debris.

Step 2: Mark the Holes

Use the provided drilling template (if included) or measure and mark the hole locations with a pencil. Use a level to ensure the plate will be perfectly straight.

Step 3: Drill the Holes

Drill pilot holes at the marked locations. For brick or concrete surfaces, use a masonry drill bit. For wood or vinyl, a standard drill bit is suitable.

Step 4: Install the Plaque

Align the plate with the pre-drilled holes and insert the provided screws. Tighten firmly but not excessively to avoid damaging the material. If your plate is a 3D floating type, install the spacers first before attaching the numbers.

Step 5: Finishing Touches

If screw covers are provided, install them for a cleaner look. Clean the surface of the plate with a soft cloth to remove fingerprints.

Maintenance Tips

Your FAVPRO products are designed to withstand Canadian weather, but occasional cleaning with mild soapy water will extend their like-new appearance.

Need help? Contact our team for personalized advice on installing your address sign.

Need help? Contact our team for personalized advice on installing your address plaque.